True/False Indicate whether the statement is
true or false.
|
|
1.
|
Cables on the reel do not need to be tested before installation as long as they
do not show physical damage.
|
|
2.
|
Midspan pulls are used when the total length to be installed is too long
for a single pull.
|
Multiple Choice Identify the choice that best
completes the statement or answers the question.
|
|
3.
|
Fiber optic cable should be __________ off the spool to prevent twisting.
a. | Figure-8ed | b. | Spun | c. | Rolled | d. | Cut |
|
|
4.
|
When cable needs to be laid on the ground for intermediate or long pulls, it
should be laid out in a ________ to prevent twisting.
a. | Large oval loop | b. | Perfect circle | c. | Round
pen | d. | Figure 8 |
|
|
5.
|
Swivel pulling eyes and figure-8ing cable is used to prevent _________.
a. | Putting a twist in the cable | b. | Not tangling the cable strength
members | c. | Kinking the cable | d. | Damaging the cable
spool |
|
|
6.
|
Swivel pulling eyes should be attachched to the __________ of the cable.
a. | Jacket | b. | Armor | c. | Reel | d. | Strength
members |
|
|
7.
|
Fiber optic cables have a minimum bend radius of _________ times the cable
diameter while under tension during pulling.
|
|
8.
|
Fiber optic cables have a minimum bend radius of _________ times the cable
diameter under NO tension after pulling.
|
|
9.
|
Jetting or blowing fiber refers to an installationmethod that ________ the cable
into the duct while __________ it on a high speed stream of air.
a. | pushes, floating | b. | pushes, also pushing | c. | pulling,
assisting | d. | blows, floating |
|
|
10.
|
At manholes or handholes where the cable is being spliced, each cable needs to
be _________meters long to allow splicing and service loops.
|