|
|
|
1.
|
Every network and every installation is different. As a result, it is only
possible to give general guidelines for design.
|
|
|
2.
|
What does this photo illustrate?  A. | The relative size of copper cabling replaced by POL fiber optic
cable | B. | Copper cables needed to power an ONT | C. | How UTP cables are bundled for
installation | D. | That fiber optic cables are always orange or yellow |
|
|
|
3.
|
FTTO work area switches are connected by ___ fibers like most fiber optic
links.
|
|
|
4.
|
Each splitter has ___ fiber(s) going to the OLT and ___ fiber(s) going to each
ONT since the PON system uses wavelength-division multiplexing to allow full duplex transmission over
one fiber.
A. | 1, 32 | B. | 1, 1 | C. | 2,
1 | D. | 1, 2 |
|
|
|
5.
|
Centralized fiber using media converters will generally use ___ fiber depending
on the length of the runs and the speed of the network.
A. | OM2 or OM3 | B. | OS1 or OS2 / G.652 | C. | Any singlemode
fiber | D. | Low water peak fiber |
|
|
|
6.
|
FTTO and passive OLANs need ___ fiber.
A. | OM2 or OM3 | B. | OS1 or OS2 / G.652 | C. | OM1e
fiber | D. | Low water peak fiber |
|
|
|
7.
|
Singlemode fiber should only use prepolished/splice connectors or prefab cable
assemblies (factory terminated) to meet network requirements for___________.
|